Manual

If you bought a ready-to-go Naked GoPro, you can click here to go to the User Manual

Naked GoPro Assembly Manual

Tools Needed:

- Soldering iron
- Solder
- M2 screwdriver
- Tweezers
- Knife


If you have any questions or need further assistance, feel free to email us at info@engelsaerials.com.

Step-by-Step Instructions

1. Insert the Sensor into the Case

Carefully slide the sensor into the designated slot in the case.

Insert the Sensor

2. Secure the Sensor

Screw in the M1.4 x 4mm screws into the two holes to secure the sensor in place.

Secure the Sensor

3. Attach the Lens Protector

Place the lens protector onto the case to protect the lens during assembly.

Attach the Lens Protector

4. Install the Front Screen

Slide the front screen into the case and gently push it into position. Ensure the flat cable is positioned underneath the screw holder.

Front Screen 1 Front Screen 2

5. Install the Motherboard

Insert the motherboard into the case and secure it using the provided screws. IMPORTANT: Use the M1.4 x 3mm screw in the bottom-right corner to avoid piercing the flat cable.

Install the Motherboard

6. Connect the Flat Cables

Connect the flat cable of the sensor, the front screen, and the cable from the NamelessRC BEC Module to the motherboard.

Flat Cable 1 Flat Cable 2

7. Attach the BEC Board

Connect the flat cable to the BEC board. Stick the BEC board on top of the SD card reader using the 3M double-sided tape.

Attach the BEC Board

8. Install the Fan

Thread the fan cable through the small hole in the case, secure the fan using nylon screws and nuts, and ensure the sticker side faces inward.

Fan 1 Fan 2

9. Finalize the Assembly

Secure the case with the final four screws (M1.7 x 10mm). Your Naked GoPro is now fully assembled and ready to capture amazing footage.

Finalize Assembly

User Manual

1. Buttons

  • Left button: Power on
  • Right button: Record

2. Connecting Naked GoPro to Your Phone

If you want to connect your Naked GoPro to your phone using the Quik app, follow these steps:

  • Turn on Bluetooth on your phone.
  • Open the GoPro Quik App on your phone and be ready to click on the search/add/connect to GoPro icon.
  • Keep your GoPro pointing at the QR Code below at the optimal distance for recognition until the next step.
  • Press the MODE button 3 times.
  • On the GoPro APP, click on the search/add/connect to a GoPro icon. That’s it!

GoPro Labs WiFi Hack QR Code Naked GoPro

3. Using the QR Control App

You can also use an app called 'QR Control' to configure settings through QR codes.

If you have any questions or need support, contact us at info@engelsaerials.com. Happy filming!